Instruction manual

3-2
Especially, select the FAT mode since the card of larger capacity than 32 MB is
formatted with the Windows XP, the FAT32 file system will be selected in default
status. The FAT mode should be selected.
･ A memory card operated with "Vcc=5 V" cannot be used.
･ When the card cannot be inserted as far as it goes, remove it. Confirm the
direction of the card, then insert the card again. Otherwise, you may damage the
card.
･ Do not remove the card or turn the power off while in access operation.
8 Ventilation Hole
Do not block airflow through the ventilation hole. Otherwise, you run the risk of fire
or instrument damage.
3.2 Rear Panel
Figure 3-2 shows the LT 4400 rear panel.
Figure 3-2 Rear panel.
9 Genlock signal Input Connector (GENLOCK)
Loop-through input accepts the external reference signal.
Refer to Chapter 7, “GENLOCK SIGNAL SETTINGS (GL SETTING)”.
10 Analog Black Signal Output Connector (BLACK OUTPUT)
Outputs the analog black burst signal and HDTV tri-level sync signal.
Refer to Chapter 8, “ANALOG BLACK SIGNAL SETTINGS (BLK SETTING)”.
11 Word Clock Output (WCLK)
Outputs the 48 kHz word clock signals.
Refer to Chapter 10, “WORD CLOCK SETTING” (WCLK SETTING).
12 SDI Output Connector (SDI OUTPUT)
Outputs the serial digital signal. It is the switching system of the SD/ HD, and outputs
the same signal.
Refer to Chapter 9, SDI SIGNAL SETTINGS (SDI SETTING)”.
13 Grounding Terminal
WARNING