User manual

ManualsBrandsCORBERO ManualsDomestic AppliancesFD6170S/6

Changing the opening direction of

the doors

Before carrying out any operations, remove the plug

from the power socket.

To change the opening direction of the door,

proceed as follows:

1. remove the upper hinge taking care that the door

does not fall off

2. remove the freezer door by lifting it up slightly

3. remove the upper plug of the freezer door and

refit on the opposite side

4. remove upper top cover and refit on the opposite

side

5. unscrew and remove the central hinge (H)

6. pay attention to remove also the spacer litted

behind the central hinge (H)

7. remove the refrigerator door by lifting it up slightly

8. remove the upper plug of the refrigerator door and

refit on the opposite side

9. remove the plugs (u) which are situated on the

lower part of the appliance

10. disassemble the lower hinge (e), remove the

screws, and refit on the opposite side

11. disassemble the pivot pin (f) on the lower hinge

and the washer (h) and replace them in the other

hole of the lower hinge

12. refit the plugs (u) on the opposite side

13. insert the refrigerator door on pivot pin (f) of the

lower hinge (e)

14. insert the pivot pin of the central hinge in left

hole of the refrigerator door and fix the hinge with

the spacers.

15. insert the freezer door on pivot pin of the central

hinge

16. refit the upper hinge on the opposite side

17. in case one does not want to carry out the above

mentioned procedure, contact the nearest After

Sales Service. The After Sales Service specialist

will carry out the reversibility of the doors at your

cost.

Warning: The doors can be aligned by adjusting the

middle hinge. The middle hinge can be adjusted

horizontally, with the help of a tool, after having

slackened the two screws.

Warning: After having reversed the opening

direction of the doors check that all the screws are

properly tightened and that the magnetic seal

adheres to the cabinet. If the ambient temperature is

cold (i.e. in Winter), the gasket may not fit perfectly

to the cabinet. In that case, wait for the natural fitting

of the gasket or accelerate this process by heating

up the part involved with a normal hairdrier.