User manual

16
Electrical connection
Before plugging in, ensure that the voltage and
frequency shown on the serial number plate
correspond to your domestic power supply. Voltage can
vary by ±6% of the rated voltage.
For operation with different voltages, a suitably sized
auto-transformer must be used.
The appliance must be earthed.
The power supply cable plug is provided with a contact
for this purpose.
If the domestic power supply socket is not earthed,
connect the appliance to a separate earth in
compliance with current regulations, consulting a
specialist technician.
INSTALLATION
Location
The appliance should be installed well away from
sources of heat such as radiators, boilers, direct
sunlight etc.
Ensure that air can circulate freely around the back of
the cabinet. To ensure best performance, if the
appliance is positioned below an overhanging wall unit,
the minimum distance between the top of the cabinet
and the wall unit must be at least 100 mm. Ideally,
however, the appliance should not be positioned below
overhanging wall units. Accurate levelling is ensured by
one or more adjustable feet at the base of the cabinet.
NP00
100 mm10 mm
10 mm
The Manufacturer declines all responsibility if
the above safety precautions are not observed.
This appliance complies with the following
E.E.C. Directives:
- 87/308 EEC of 2/6/87 relative to radio interference
suppression.
- 73/23 EEC of 19.2.73 (Low Voltage Directive) and
subsequent modifications;
- 89/336 EEC of 3.5.89 (Electromagnetic
Compatibility Directive) and subsequent
modifications.
Important:
It must be possible to disconnect the appliance from
the mains power supply; the plug must therefore be
easily accessible after installation
Rear spacers
Inside the appliance you find two spacers which
must be fitted as shown in the figure.
Slacken the screws and insert the spacer under the
screw head, then re-tighten the screws.