User manual

11
PR33
Hc
Ha
PR167
Ha
Hb
8mm
Ha
8mm
K
Apoye las guías (Ha) sobre la parte interna superior
e inferior de la puerta del mueble como se indica en
la Fig. y marque la posición de los agujeros
externos. Después de haber preparado los agujeros,
atornille las guías con tornillos sobre la puerta del
mueble.
Abra la puerta del aparato y la del mueble de aproxi-
madamente 90°. Coloque les escuadras sobre las
guías. Mantenga juntas la puerta del aparato y la dei
mueble y marque los agujeros como mostrado en la
figura.
Quitar las escuadras y marcar a 8 mm del borde
externo de la puerta con el clavo (K).
2
1
m
m
2
1
m
m
ca. 50 mm
90°
90°
ca. 50 mm
Aplicar a presión la tapa (Hc) sobre la guía (Ha).
14
CONTENTS
Warnings 13
Use 14
Cleaning the interior 14
Operation 14
Temperature regulation 15
Fresh food refrigeration 15
Freezing fresh food 15
Storage of frozen food 15
Thawing 15
Ice-cube production 15
Shelf holders 15
Movable shelves 15
Positioning the door shelves 16
Freezing Calender 16
Hints 16
Hints for refrigeration 16
Hints for freezing 16
Hints for storage of frozen food 16
Maintenance 17
Periodic cleaning 17
Periods of no operation 17
Interior light 17
Defrosting 17
Customer service and spare parts 18
Technical information 18
Installation 18
Location 18
Electrical connection 18
Door reversibility 19
Instructions for built-in 19
Installation
• During normal operation, the condenser and
compressor at the back of the appliance heat up
considerably. For safety reasons, minimum
ventilation must be as shown in the relevant
Figure.
Attention: keep ventilation openings clear of
obstruction.
• If the appliance is transported horizontally, it is
possible that the oil contained in the compressor
flows in the refrigerant circuit. It is advisable to
wait at least two hours before connecting the
appliance to allow the oil to flow back in the
compressor.
• There are working parts in this product which
heat up. Always ensure that there is adequate
ventilation as a failure to do this will result in
component failure and possible food loss. See
installation instructions.
• Parts which heat up should not be exposed.
Wherever possible the back of the product should
be against a wall.
• If the appliance has been transported
horizontally, it is possible that the oil contained in
the compressor ílows in the refrigerant circuit. It
is advisable to wait at least two hours before
connecting the appliance to allow tl¦e oil to flow
back in the compressor.
Environment Protection
This appliance does not contain gasses which
could damage the ozone layer, in either its
refrigerant circuit or insulation materials.The
appliance shall not be discarded together with
the urban refuse and rubbish. Avoid damaging
the cooling unit, especially at the rear near the
heat exchanger. Information on your local
disposal sites may be obtained from municipal
authorities.The materials used on this appliance
marked by the symbol are recyclable.
Disposal of old Appliances
The symbol on the product or on its packaging
indicates that this product may not be treated as
household waste. Instead it shall be handed over to
the applicable collection point for the recycling of
electrical and electronic equipment. By ensuring this
product is disposed of correctly, you will help prevent
potential negative consequences for the environment
and human health, which could otherwise be caused
by inappropriate waste handling of this product. For
more detailed information about recycling of this
product, please contact your local city office, your
household waste disposal service or the shop where
you purchased the product.
Cleaning the interior
Before using the appliance for the first time, wash
the interior and all internal accessories with luke-
warm water and some neutral soap so as to remove
the typical smell of a brand-new product, then dry
thoroughly.
Do not use detergents or abrasive
powders, as these will damage the finish.
Operation
Insert the plug into the wall socket.
Open the refrigerator door and turn the thermostat
knob, clockwise, beyond the «O» (STOP) position.
The appliance will start to operate.
USE