User manual

24
INSTALLATION
Emplacement
Placez de préférence votre appareil loin d’une
source de chaleur (chauffage, cuisson ou rayons
solaires trop intenses).
Pour des raisons de sécurité, la ventilation doit être
prévue comme indiqué dans la Fig.
Appreil positionné sous armoires murales de cuisine
en surplomb (voir Fig. A).
Appreil positionné sans armoires murales de cuisine
en surplomb (voir Fig. B).
Attention: veillez à ne pas obstruer les
ouvertures de ventilation.
Mettez l’appareil d’aplomb en agissant sur les pieds
réglables.
Entretoises postérieures
Dans le sac avec la documentation, il y a deux
entretoises qui dolvent être montées comme
indiqué dans la figure.
Desserrez les vis et introduisez les entretoises sous
la tête de vis, puis resserrer.
NP008
100 mm15 mm
15 mm
A
B
D594
Important: L’appareil doit pouvoir être débranché du
secteur ; il est donc nécessaire que la fiche reste
accessible une fois que l’installation est terminée.
B
A
Arrêts pour tablettes
Votre appareil est équipé d’arrêts pour clayettes qui
permettent de les bloquer pendant le transport.
Pour les enlever, procéder de la façon suivante :
soulevez à l'arrière la clayette et poussez-la vers
l'avant jusqu'à ce qu'elle se dégage. Retirez les
arrêts.
29
CONTENTS
Warnings 28
Use 30
Control panel 30
Cleaning the interior 30
Operation 30
Temperature regulation 30
Ambient switch 30
Freezing fresh food 30
Storage of frozen food 31
Thawing 31
Ice-cube production 31
Fresh food refrigeration 31
Movable shelves 31
Positioning the door shelves 31
Hints 32
hints for refrigeration 32
Hints for freezing 32
Hints for storage of frozen food 32
Maintenance 33
Periodic cleaning 33
Periods of no operation 33
Interior light 33
Defrosting 33
Customer service and spare parts 34
Installation 35
Location 35
Shelf holders 35
Rear spacers 35
Electrical connection 36
Changing the opening direction of the doors 37
• Do not place carbonated or fizzy drinks in the
freezer as it creates pressure on the container,
which may cause it to explode, resulting in
damage to the appliance. Do not use a
mechanical device or any artificial means to
speed up the thawing process other than those
recommended by the manufacturer. Never use
metal objects for cleaning your appliance as it
may get damaged.
Installation
• During normal operation, the condenser and
compressor at the back of the appliance heat up
considerably. For safety reasons, minimum
ventilation must be as shown in the instructions.
Attention: keep ventilation openings clear of
obstruction.
• Care must be taken to ensure that the appliance
does not stand on the electrical supply cable.
Important: if the supply cord is damaged, it must
be replaced by a special cord or assembly availa-
ble from the manufacturer or its service agent.
• If the appliance is transported horizontally, it is
possible that the oil contained in the compressor
flows in the refrigerant circuit. It is advisable to
wait at least two hours before connecting the
appliance to allow the oil to flow back in the
compressor.
• There are working parts in this product which
heat up. Always ensure that there is adequate
ventilation as a failure to do this will result in
component failure and possible food loss. See
installation instructions.
• Parts which heat up should not be exposed.
Wherever possible the back of the product should
be against a wall.
Environment Protection
This appliance does not contain gasses which
could damage the ozone layer, in either its
refrigerant circuit or insulation materials.The
appliance shall not be discarded together with
the urban refuse and rubbish. Avoid damaging
the cooling unit, especially at the rear near the
heat exchanger. Information on your local
disposal sites may be obtained from municipal
authorities.The materials used on this appliance
marked by the symbol are recyclable.