Manualshelf

Instructions for use

ManualsBrandsCorally ManualsBuggy - Truggy - All Terrain RCMOXOO XP 2WD Truck 1/10th Brushless RTR Combo
11121314151617181920
14
Charging Lithium Battery in CHARGE Mode
This charging mode is for charging LiPo/LiFe/LiIon battery in normal mode.
Note: We recommend charging lithium batteries with a balance lead in the balance mode only.
The left side of the first line shows the type of battery you
choose. The value on the left of the second line of the charger is
current the user sets. After setting the current and voltage, press
the START/ENTER button for more than 3 seconds to start the
process.
This screen displays the number of cells you set up and the
processor detects.
R=Number of cells detected by charger.
S=Number of cells set by you at the previous screen.
If both numbers are identical you can start charging process.
If not, press BATT TYPE/ STOP button to go back to previous
screen to recheck the number of cells of the battery pack before
going ahead.
This screen displays the number of cells you set up and the
processor detects.
R=Number of cells detected by charger.
S=Number of cells set by you at the previous screen.
If both numbers are identical you can start charging process.
If not, press BATT TYPE/ STOP button to go back to previous
screen to recheck the number of cells of the battery pack before
going ahead.
This screen shows the real-time status during charge process.
Press BATT TYPE/STOP button once to stop the charge process.
Charging Lithium Battery in FAST CHARGE Mode
Charging current will drop towards the end of charging, a specific CV process is reduced to the charging
process earlier. In fact, the charging current reach 1/5 when the charging process comes to 1/10 during CV
period, charging capacity is a little smaller than normal charging but charging time is shorted accordingly.
The value on the left side of the second lines shows the charge
current. The value on the right side of the second lines shows the
battery pack’s voltage. After setting current and voltage, press
the START/ENTER button for more than 3 seconds to start the
process.
Lithium Battery Program for Li-Po • Li-Po HV • Li-Fe • Li-Ion