Instructions for use

LITHIUM POLYMER BATTERY SAFETY PRECAUTIONS
Never drop this type of battery, it will be deformed and we advise you never to try to charge a
deformed battery as this may cause swelling, leakage and even fire.
Soldering Connectors
Use a soldering iron where the temperature can be controlled.
The temperature must not exceed 350°C and the time must not exceed 3 seconds.
Perfectly isolate all electrical connections from the battery circuit.
Battery installation
The battery must be installed in the model on a flat surface.
The battery must be protected from physical contact with any other part of the model.
The battery must be protected against shocks and splashing of materials from outside the
model. The battery and all electrical connections must be protected against splashing liquids.
Electrical cables and connectors must be protected against accidental tearing.
Recycling after use
- If the battery swells during charging, stop charging immediately and disconnect the battery
from the charger. Leave the battery outside for a few hours and observe.
- Before recycling your defective battery, it must be neutralized. Take a plastic container, fill it
with water and add a lot of salt until the water becomes opaque. Place the LiPo battery in the
water and leave for 24 hours. Check with a voltmeter that the voltage is 0.0V.
- Then recycle the battery according to the instructions of your country/region. Never dispose of
a LIPO battery with domestic waste.
- Never incinerate nor dispose of the cells in a fire. These may cause firing of the cells, which is
very dangerous and is prohibited.
- The cells shall never be soaked with liquids such as water, seawater drinks such as soft drinks,
juices coffee or others.
Team Corally • Geelseweg 80 • B-2250 OLEN • Belgium
Tel: [phone] • [e-mail] • www.corally.com
Contents © Copyright 2019