Instructions for use

6
PLEASE NOTE :
• For easy recognition, the motor beeps at the
same time when the GREEN LED ashes.
• When “N” (the number) is equal to or bigger
than 5, we use a long ash to represent “5”.
For example, the GREEN LED ashes a long
ash (and the motor beeps a long beep at the
same time) indicating you are in the 5th pro-
grammable item; if the GREEN ashes a long
ash and a short ash (and the motor beeps a
long beep and a short beep at the same time)
indicating you are in the 6th programmable
item; a long ash and two short ashes ( a
long beep and two short beeps at the same
time) indicating you’re in the 7th programma-
ble item and so on.
1. Programming The ESC With The Set Button
• Restore the default values with the SET button
Press and hold the SET button for over 3 seconds anytime when the throttle trigger is at the neutral position (except
during the ESC calibration and programming) can factory reset your ESC. RED & GREEN LEDs ash simultaneously
indicating you have successfully restored all the default values within your ESC. Once you power the ESC OFF, and
then back ON, the settings will be back in the default mode.
1. During the Start-up Process
• The RED LED ashes rapidly, showing indications that the ESC doesn’t detect any throttle signal or the neutral throttle
value stored on your ESC may be different from the current value stored on the transmitter.
• The GREEN LED ashes “Number” times indicating the number of LiPo cells you have connected to the ESC.
2. In Operation
• RED & GREEN LEDs die out when the throttle trigger is in throttle neutral zone.
• The RED LED turns on solid when your vehicle runs forward. The GREEN LED comes on when pulling the throttle trigger
to the full (100%) throttle endpoint.
• The RED LED turns on solid when you brake, the GREEN LED will also come on when pushing the throttle trigger to the
full brake endpoint and setting the “maximum brake force” to 100%.
• The RED LED turns on solid when you reverse your vehicle.
3. When Some Protection is Activated
• The RED LED ashes a short, single ash and repeats (☆,☆,☆) indicating the low voltage cutoff protection is activated.
• The GREEN LED ashes a short, single ash and repeats (☆,☆,☆) indicating the ESC thermal protection is activated.
• The GREEN LED ashes a short, double ash and repeats (☆☆,☆☆,☆☆) indicating the MOTOR thermal protection is
activated.
ESC PROGRAMMING
FACTORY RESET
LED STATUS
SIMPLIFIED DECLARATION OF CONFORMITY
MANUFACTURER :
Team Corally hereby declares that the speedcontroller system type TOROX 60 complies with the Directive
2014/53/EU.
The full text of the EU Declaration of Conformity is available at the following Internet address:
www.corally.com
Team Corally, Geelseweg 80, B-2250 OLEN, Belgium, [e-mail]