Instructions for use

2
WARNINGS
SPECIFICATIONS
CONNECTIONS
Brushless Motor
Power Switch
Receiver
Servo
LiPo Battery
Speedcontroller
Temp. monitoring cable
Please observe the connection diagram !
DO NOT reverse the polarity
- Make sure that all wires and connections are properly insulated before connecting the ESC to the motor and battery.
A short circuit can cause irreparable damage to the ESC.
- Make sure all devices are properly connected, a poor connection can result in loss of vehicle control or damage to the
ESC.
- Read the manuals of all power supplies and make sure that the power supply conguration is correct before using this
ESC.
- Please use a soldering iron with a power of at least 60W to solder all inputs/outputs cables with connectors.
- Do not hold the vehicle in the air or start it at full throttle, as rubber tires can «expand» to an extreme size and even
crack and cause serious injury.
- Stop using the ESC when the temperature of its housing exceeds 90°C/194°F, otherwise the ESC will be destroyed
and your engine may be damaged. We recommend setting the «ESC Thermal Protection» to 105°C/221°F (this is the
internal temperature of the ESC).
- Please remove the ESC cooling fan before exposing the vehicle to liquids and dry it completely immediately after use.
- Always disconnect the batteries after use, as the ESC will always consume power if connected to the battery (even if
the ESC is off). A long-lasting contact will cause the battery to completely discharge and damage it. This will NOT be
covered by the warranty.
Cont./Peak Current 60A / 450A
Motor Type Sensorless/Sensored Brushless Motor(only in sensorless mode)
Applications 1/10th Buggy, On-road, and Light-weight 2WD SCT/Truck/Monster Truck
Motor Limit
Brushless Motor Limit with 2S LiPo : 6000 Kv (3652 size motor)
Brushless Motor Limit with 3S LiPo : 4000 Kv (3652 size motor)
LiPo /NiMH Cells 2-3S LiPo / 6-9 Cell NiMH
BEC Output 6V/7.4V Switchable, Continuous Current of 3A (Switch-mode)
Cooling Fan Powered by the stable BEC voltage of 6V/7.4V
Connectors
Input End: No Connectors
Output End: 3.5mm Female Gold Connectors (pre-soldered onto the PCB of the ESC)
Size/Weight 39.4 x 32.8 x 23.1mm (w/o Fan) / 67.8g
Programming Port FAN/PRG Port