Specifications

PrintMaster Monet.
Set Up.
Open right hand side door to reveal
the ink supply bottles and waste bottle
Unscrew lids of supply bottles and fill
each with ink. The shoulder of the
bottle should be the maximum fill
level. The minimum fill level should be
considered as a fingers width from the
bottom of the supply bottle
Empty the waste bottle before it is
full. Contact your supplier for disposal
advice.
The flatbed is fitted with a magnetic
base to attach and fix your custom jig
in place for printing
Connect the power lead, USB cable
and control panel cable as below. Do
not power on until the ink supply
tanks are filled with ink and you are
promted to do so during the first time
driver installation process
Please Note: Do not allow the
supply bottle to run dry as this can
cause damage to the ink supply
system and print head
Fitting Custom Jig.
Cable fitting
6.