Specifications

13.
3 Flatbed moves backward at one touch and stop at second touch
6 Push button for 3 seconds to start a head clean (flatbed must be
in print ready position)
When printer is printing, printing will stop when pressing this button
Startautoheightfunctionwhenflatbedisatthefrontposition
7 Ready to print and enable multi print with same images by touch
Push and hold for 3 seconds to enter Function mode
Function Mode
This mode can be used for adjusting printer settings. Press and hold button 7 for 3
seconds to enter this menu (in Test or Run mode)
Press button 7 to cycle to the next setting. Button 4 increases value and button 5 decreases value.
Halogen lamp on/ off
Auto head clean timer
FlatBed forward speed control
(recommended speed 40% ~ 50%)
FlatBed backward speed control
(recommended speed 40% ~ 50%)
1.SETTemperatur
e(30%)
2.SET Temperatur
eMODE (OFF)
3.Automatic Clea
ning (48h)
4.FRONTSPEED SET
SPEED (40%)
5.BACK SPEED SET
SPEED (40%)
PrintMaster Monet.
Control Panel and Printer Operation.
4 Print head moves up away from flatbed
5 Print head moves down towards flatbed
after print
Halogen lamp temperature control
6.1234567
---Y---
Sensor test