Specifications

PrintMaster Monet.
Control Panel and Printer Operation.
12.
A. Control panel operation
Button “1” Power
Button “2” Forward
Button “3” Backward
Button “4” Head up
Button “5” Head down
Button “6” Auto height adjust
Button “7” Ready to print/ Repeat print
B. Printer Mode
Test mode function
When unit is switched on, printer will start in Test mode. In this mode you can do
Button Printer operation Display
1 Power on printer and print goes to Run Mode
2 Flatbed moves forward at one touch and stop at another touch
3 Flatbed moves backward at one touch and stops at another touch
4 Print head moves up away from flatbed
5 Print head moves down towards flatbed
6 Initiate auto height adjustment
7 Push and hold 5 seconds and to enter Function Mode
Run mode function
After printer initialisation you can do the following:
1 Power off printer and goes to Test Mode
2 Flatbed moves forward at one touch and stop at another touch
Call to Supplier
Ready to print
the following:
Button Printer operation Remark
table continued over page...