Specifications

a. If nozzle check is continuously bad after printer head cleaning & capping station
replacement,you may need to replace your printer head:
1. Power off printer
2. Take all dampers out from printer head carriage
3. Remove screw on side of head carriage and remove side cover
Note: These arms are very delicate,so do not lift with a lot of force.
4. Remove two fixing screws and lift our print head
5. Disconnect two FFC head cables from printer head
6. Replace printer head and reconnect cables
7. Put new printer head back in original position
8. Tighten two screws on the printer head
9. Put flat cables coverback in original position
10. Power printer on
b. Ink charge procedure (Windows only):
1. Run SSC Service Utility from the CD-ROM
2. Select your printer from the drop down lists in the configuration window
3. Close the window
4. Select initial charge from the head cleaning menu in the taskbar icon
5. Wait for completion
PrintMaster Monet.
Maintenance.
Annually ( or as needed )
A . Printer Head replacement
11.