Specifications

Monthly
A . Clean the horizontal encoder strip (seen below) in the front of the printer frame with rubbing
alcohol and cotton buds.
B. Cleaning vertical encoder:
a. Located at rear of printer near vertical motor
Quarterly (or as needed)
A . Capping Station Replacement:
a. If nozzle check is not good after head cleaning, check the change date of capping
station
b. If change date is 3 months old, your PrintMaster needs a capping station replacement:
1. Power off printer
2. Open printer cover
3. Release screws for supporting capping station
4. Disconnect signal cable
5. Take capping station out from the printer frame
6. Put new capping stationinto the printer frame
7. Reconnect signal cable
8. Tighten support screws for capping station
9. Make sure the waste ink tube is emptying into the waste ink bottle
PrintMaster Monet.
Maintenance.
10.