User guide

DaVinci Pro CD printer.
Printing paper.
1.
An area of free, level desk space, the size of
the paper carrier is needed on the output side
of the printer.
2.
Remove the film protecting the adhesive area.
Place the empty paper carrier onto the input
guide. The corner cutout in the carrier is
positioned towards the printer and the
adhesive area facing up.
The carrier fits between the nylon guide
blocks and should run freely between them.
3.
Align the paper with the front edge of the
cutout in the paper carrier (A), and then the
edge marked with arrows (B). Press down the
paper onto the adhesive area and smooth out
(C).
4.
If you are printing on photo paper, using the
photo paper setting, it is necessary to insert
the paper carrier before spooling the image to
the printer. (Otherwise the print image will
start before the top edge of the paper).Only
one copy can be printed.
If you are printing using the plain paper
setting it is necessary to spool the image to
the printer, wait for the red feed/ink status
indicator to light, and then insert the paper
carrier. Multiple copies can be printed.
In either case, to insert the paper carrier,
press the feed/clean button on the control
panel (A), whilst pushing gently but firmly
against the middle of the rear edge of the
paper carrier. The printer will draw in the
paper carrier. Stop pushing the paper carrier
when your finger reaches the edge of the
cutout in the input guide (B).
5.
The paper carrier and paper are drawn
through by the printer and exit onto the
desktop at the output end of the printer. The
paper carrier must drop onto the desktop to
keep the paper tensioned during printing.
Warning! Printing large areas of deep colour
onto unsuitable paper will cause the paper to
swell, rise, and touch the printhead.
Remove the output support.
Positioning the paper carrier.
Positioning the paper.
Printing. (At this point there are two
different techniques to use).
Output.
A
B
B
C
1
2
3
4
5