Specifications

DaVinci Pro 6-6 CD printer.
Preparing the ink tanks.
1.
Remove the top tray & its contents.
Carefully lift the printer from its box leaving
the two foam ends on the printer. Place on a
table with easy access all around. Remove
both foam ends being especially carful with
the ink tank end so as not to pull or damage
any pipes.
Locate the small bag containing 6 clear filters.
Lift the ink tank assembly from its tray &
place upright on the bench.
Remove the coloured rear transport stoppers
being careful not to spill ink.
Gently press the clear filters into the recess
from which the stopper was fitted.
Once all the clear filters are fitted you can
place the ink tank assembly back into its tray.
THE INK SYSTEM IS READY FOR USE.
2.
You will need:
Copytrax CD printer refill ink (dye based).
Protective gloves & goggles.
Remove the top from the refill bottle(1) & fit
the supplied nozzle(2).
Cut the top of the nozzle off with a sharp
knife(3) to allow the ink to flow.
Refilling can be done with the ink tank in its
tray.
Pull the front coloured stopper from its
hole(4) & carefully refill with Copytrax CD
printer ink(5). Refit the stopper before use.
Fitting the air filters.
Ink Filling
When the printer is packed at the factory the
ink tanks will have stoppers in the air vents to
stop any ink leaking in transit. The procedure
below explains how to fit the air filters to the
vents enabling clean ink flow for trouble free
printing. Once the air filters are installed you
might need to do 2-3 print head cleans to get
the ink flowing at its best.
CAUTION! PRESSING THE FILTER IN TOO
HARD WILL CRACK THE INK TANK.
ALWAYS KEEP THE INK TANKS UPRIGHT.
WARNING..ONLY USE COPYTRAX CD PRINTER
INK IN THIS PRINTER. DAMAGE CAUSED BY
NON-COPYTRAX APPROVED INK WILL NOT BE
COVERED .UNDER WARRANTY
1
2
3
4
5