Specifications

80
The small line next to the
Text Connected shows if
the printer is accessible.
If yes, the line will rotate
slowly.
Specific control - The button „Open Tray“ will open the tray, the button „Close Tray“ will close the
tray of the printer. If the printer is busy, or in an error condition, these button are out of function.
Position Calibration This group of functions gives you the possibility to centre
and calibrate the print out.
Pressing the button „Print Calibration Test File“ will print a specific file which
enables you to centre the print out via the Margin settings.
Look at the printed image and figure out the offset to the actual margin settings.
A
distance of 1mm is equivalent to 100 steps.
Add the offset you need to the actual margins and save the values via the corre-
sponding button.
The „Eject Position“ is the position where the tray stays when the tray is open.
Printing image - shows the values
that say how and by how much and
which direction is shifted from the print
media. Or if it is exactly in the middle.
A
value of 1 mm corresponds to a
value of 100 steps.
They add the value, or subtract the
values listed in the windows dialog
Position Calibration.
Printer calibration - the printer prop-
erties in the Maintenance tab, run the
Printer Service Terminal. After reading
the values , click Open T
ray. When
tray is out insert Printable media. Click
on the
Close Tray. Tray will drive
inside the printer. Now click Print
Calibration Test File. The inserted
media to print the cross hairs, see
image on the left. Read the value of
media in the direction which has to
move the print media to the print. was
in the middle. The lower this value or
increase values in the Left Margin field
or Right Margin. After entering values ,
click the Save button for Left Margin
or Top Margin to save entered values.
Repeatedly press the cross hairs
Calibration Test Print File precisely
calibrates the printer.
Note: Remember that now you have to customize and print the graphics program you use. Calibrate a template in a
graphics program which you use, such as label in the Label Designer, template in Corel, etc. ..
Printer