Specifications

Disc Manager
19. How to do . . .
The following chapters describes how to do, for example: how to insert a Job, how to delete a Job, how to modify
the Job, how to create a Job, how to create a Job for write, how to create a Job for printing, how to load the image,
how to create an image from the files, ..., and more.
19.1 How to read CD or DVD disc
1. Start the Disc Manager software
2. Check the Hardware settings, see chapter 8.1, next click to OK
3. Insert master disc into Input Bin1
4. Click by mouse to the menu File --> Read Image or Read Image button from the Toolbar
5. In opened dialogue box type the name for master disc and path to store it onto HDD. Next press OK
6. Select the recorder for reading the master disc
7. Choose reading speed 32X for data disc or 24X for audio disc
8. Click to the Start button. Duplicator will take disc from input Bin1 and insert it to the recorder.
9. After loading the image, click to Close button. Now the computer has recorded an image. A disk image is in the
same format as the source disc.
19.2. How to compile the image from files
1. Click on the icon you start Disc Manager
2. Check your hardware and click OK , see section 8.1
3. On the toolbar, click on the Disc Xpress button
4. In the opened window, choose the type of compilation CD or DVD
5. Type the name (volume) for disc
6. Select the file system (for long names with graphic accents select the ISO9660 + Joliet)
7. Enter the name and location of the image to load
8. Check your settings if according to your requirements click OK.
9. In the new opened window (see up picture on the page 40) assemble your image
10. In the right window, choose the files and folders and mark them by clicking the mouse. See page 40,
Compilation section
11. Drag and drop files and folders from the the right window to the left window
12. Follow the green bar at the bottom, which shows the size of the assembled compilation
13. Now you can add or remove files and folders into or from the compilation
14. Click on the menu at Compile --> Create Image to start creating the image of the compilation
15. After creating an image is displayed a message including the path where the image was saved
16. Click OK to finish
17. Click in the menu at Compile --> Exit to close the Disc Xpress
19.3. How to create Job for record only
To create a Job for recording you have to prepare image first, see chapter 19.1 or 19.2
1. Click on the icon you start Disc Manager
2. Check your hardware and click OK, see chapter 8.1
3. On the toolbar, click on the Job Editor icon
4. Click on the Add for create a new Job, see at the chapter 4.2.1.
5. Enter name of Job
6. Click to Recording bookmark
7. Enable recording (Make tick in small box before enable recording)
8. Browse in the HDD and select the recording image (with extension *.NRG or *.ISO)
9. Enable verification file (Make tick in small box before Verify after recording)
10. Enable Burn Proof (Make tick in small box before Activate Burn Proof)
11. Choose the recording speed, we recommend the 32X for data and 24X for Audio. For DVD please setup record-
ing speed according to used media but you use recording speed lower than maximum
12. Click on the OK you create a Job for recording only
Disc Manager - How To
67