Specifications

Disc Manager

Sample bins:

Gamma Bins Alpha Bins Delta Bins

Use Rotation Head -There is item for rotation discs to index mark by use a special rotation head. For more infor-

mation read chapter 4.2.1 Create New section Disc Rotation.

Enable Recorders - In this section you can select how many recorders you will use and which of this will you use.

At the right side of each recorder is Check button. This button is for checking if selected recorder is really recorder

with right position in duplicator tower. After click this button the Disc Manager ejects and close tray of selected

recorder. You have to check if it was recorder in right position. When you have connected autoloader through the

Fire-Wire you pay attention to right right recorders positions.

Note: Number of used recorders is enable by license key. You can´t use recorders more then is enable.

Enable Printer -

Click by mouse to a little window you enable the printer.

Printer - you have to select type of your printer and correspondent printer drive that you have installed in Windows.

The most often used printer are ODP100, ODP200,ODP500 and P55.

Construction - Construction of some printers don't allow you to print during autoloader movement, because their

tray goes out of printer during printing. For these type of printer is necessary to set Load recorders is not possible

during printing,e.g. Signature printers. Other printers are printing inside the printer so the loader needn't wait for

printer tray, e.g. ODP100, ODP200, ODP500, ...

Load recorders is not possible during printing - for printers whose tray goes out during printing

Load recorders during printing

- for printers which are printing inside the printer

Monitoring - If you have ODP100 or ODP200 printer then you can check monitoring ink levels in cartridges. Then

Disc Manager is checking this level and if there is no ink, warning message will displayed.

Important note: If this will not be conﬁgured correctly, Disc Manager will not work properly!

7.2 Software Options

When Disc Manager is installed then you must set the environment variable. After Disc Manager starts click by

mouse to menu Setup -> Software Options. In opened Software Optionwindow you can see three bookmarks:

• Temporary Space - set-up all necessary parameters for good function the Disc Manger software

• Printing Options - set-up important parameters for good function printer and set-up parameters for printing PDF ﬁle

• Autoloader Options - set-up important parameters for accurate function connected Autoloader.

Disc Manager