User guide

Job
User Guide 8-8
2
Select the Job storage (e-MPS) check box, and then select Quick copy. 2
3
You can name the job for later reference when printing from the printing system’s
operation panel. Under Job name, select Application defined for automatic naming
by the application. Or, select Custom to enter a name of your choice. The name can
be up to 31 characters. 3
4
Click OK. 4
5
When you Print from the application, the job will be saved to the hard disk while the
specified number of copies prints. 5
Print Additional Copies of Quick Copy Jobs
Note: The actual key sequence may differ depending on the model.
1
Press the MENU key at the printing system’s operation panel. 1
2
Press the S or T key repeatedly until e-MPS > appears. 2
3
Press the X key to open the submenu. 3
4
Press the S or T key repeatedly until >Quick Copy appears. 4
5
Press the ENTER key. A blinking question mark [ ? ] appears by the user name. To
set a user name, follow the instructions in Identification on page 2-5. 5
6
If the user name is correct, press the ENTER key. Otherwise, press the S or T key
until the correct name appears. 6
7
Press the ENTER key. 7
8
The job name appears with a blinking question mark [ ? ].
If this is the correct job for printing, press the ENTER key. 8
9
Otherwise, press the T or S key until the correct name appears. Then, press the
ENTER key. 9
10
Press theT or S key to specify the number of copies. 10
11
Press the ENTER key. The Quick Copy job is reprinted in the specified number of
copies. 11
Delete Quick Copy Jobs
1
Refer to steps 1 through 8 in Print Additional Copies of Quick Copy Jobs on
page 8-8. 1
2
If this is the correct job for deletion, press the ENTER key. 2
3
Otherwise, press the T or S key until the correct name appears. 3
4
After the menu for specifying the number of print copies appears, press the T key
once. Delete appears. 4