User guide

Finishing
5-3 KX Driver
Using Hole Punch
1
In your application, open the Print dialog box, then open Properties. (Select Print
from the File menu, and select Properties.) 1
2
In the Basic tab, under Destination, select a face-up or face-down finishing tray. 2
3
Click the Finishing tab, then select Punch. 3
4
Select the number of hole punches: 2 hole, 3 hole, or 4 hole. Available punch options
are set in the Device Settings tab and depend on the punch unit installed. For further
details, refer to Installing Optional Devices on page 2-1. For information on
positioning the hole punches, refer to Position the Hole Punch below. 4
• For metric specification, use 2 hole and 4 hole punch options.
• For inches specification, use 2 hole and 3 hole punch options.
5
Click OK to return to the Print dialog box. 5
6
Click OK to start printing. 6
The print job will be punched by the finishing device and delivered to the output tray.
For further details about hole punch specifications, refer to your finishing device’s
Operation Guide.