User guide

Printer Properties
2-14 KX Driver
Auto Configure can detect printing system devices such as input devices, output
devices, RAM disk size, and hard disk size. Then it updates the Device options list
in the Device Settings properties page. Auto Configure keeps the printer driver’s
Device Settings consistent with the actual printing system devices.
Note: Not all installed devices are detected by using Auto Configuration. Before
selecting OK in the Device Settings tab, check the settings to make sure they are
correct.
Auto Configure currently supports these ports for Microsoft Windows operating
systems:
• Windows 98 & ME – KPrint ports (Raw mode, LPR, and IPP) only
• Windows NT 4.0 – KPrint ports (Raw mode, LPR, and IPP) only
• Windows 2000 – TCP/IP Ports and KPrint Ports (Raw mode, LPR, and IPP)
• Windows XP – TCP/IP Ports only
TCP/IP port can be either an IP address or the printing system name (Host name).
Note: Auto Configuration is not supported for Microsoft Windows 95.
To use this feature, click Auto Configure. An “in progress” message will appear.
The check box settings in the Device options list will be changed and the 3D image
will be updated according to the device options installed. Memory and RAM Disk
information will also change based on the setting information returned.
Under the following conditions the Auto Configure tool cannot communicate with the
printing system: