User guide

Printer Properties
User Guide 2-13
exist for the older driver, then the alignment of media source values will maintain
support without the need to change the macros.
Use the Driver Info utility, available on the Kyocera Software Library CD, to compare
the source values for all installed drivers.
If the values for a given media source differ between the old and new printer drivers,
reassign the value in the new driver to match the value in the previous driver.
Compatibility settings can be adjusted by selecting Compatibility in the Device
Settings tab.
1
In the Device Settings tab, click Compatibility. 1
2
The Compatibility Settings dialog box appears. From the list in the Media source
enumeration area, select the paper supply method. The current value is listed in the
Enumerated value box.
3
Enter a new Enumerated value for the media source and click OK. You can also
restore all the parameters to the default by cllicking Reset. 2
The other options in the Compatibility Settings dialog box vary depending on
model. Options can include: 3
• Combine source and media type lists
This option changes the Basic tab of Printer Properties so that Media type and
Source are combined into one box, labelled Source.
• Enable manual duplex on network port
Use this option if you do not have a duplex unit and you want to print using
Manual Duplex (see page 3-9).
• Disable face-up reverse page order
This option prevents reverse order printing if face-up output is selected.
• Ignore application collation
Use this option to bypass the Collate setting in the application, and give priority to
the printer driver setting.
Auto Configuration
Auto Configure detects the installed device options on the printing system if it is
connected over a network. This button appears in the Device Settings Properties
page.