User guide

Printer Properties
User Guide 2-3
If you don’t know the memory capacity of your printing system, you can use Auto
Configure so the information can be automatically selected. If Auto Configure is not
available, then printing system memory can be seen on the status page. To generate
a status page, select this option from operation panel. See Auto Configuration on
page 2-13 for more information. 5
Punch Settings
When you select the check box for a finishing device shown in blue in the Device
options list, such as Finisher or Multi Finisher, the Punch Unit Settings dialog box
appears. If the device listing is already selected, double-click the option to open the
Punch Unit Settings dialog box.
Select 2 Hole, 2 & 3 Hole (for inches), or 2 & 4 Hole (for millimeters) punch option
depending on the optional Punch Unit attached to your finisher.
Assigning Custom Boxes
If you select the Hard disk check box, the Hard Disk Settings dialog box appears
and virtual mail boxes can be created. For further details, see Custom Box on
page 8-2.
Note: An installed hard disk supports the following options: Custom box, Quick
Copy, Proof and Hold, Private Print, and Job Storage.