User guide

Advanced
User Guide 9-10
1
Click Add to open the Add Security Watermark dialog box. 1
2
Type a descriptive name for your watermark in the Security watermark name text
box. The name can be different from the actual watermark text, but the name cannot
be the same as one of the standard security watermark names. After the new
watermark is added, its name appears in the Select security watermark drop-down
list. 2
If you type the same name as a previously added security watermark, when you try
to add the new watermark the driver will prompt you for a decision to replace the one
that already exists. Click Yes to replace the existing security watermark with the new
one, or click No to cancel the Add action.
If you do not type a name, and the name text box is left blank, the driver will prompt
you to type a name. A security watermark cannot be saved with a blank name.
3
Up to three lines of text can be printed as a security watermark. Though the text lines
(Line 1, Line 2, Line 3) are all optional, at least one of the lines must contain text.3
To leave a text line blank, select [None] from that line’s drop-down list.
With User Defined selected from the Line text drop-down list, type the text you want
in the text box next to the drop-down list. The maximum length of each line of text is
39 characters. As you type, your text will appear in the preview pane at the left.
As an alternative to creating your own security watermark text, you can choose one
of the following selections from the list. These options direct the printing system to
retrieve information from the computer or printer driver to print the security
watermark:
For date, time, and job selections, only a label for the selection will appear in the
preview panel. When the job is printed, the actual date, time or job information will
print as the security watermark text.
• Computer name • Mac address • Time
• Date and time • User name • IP address
• Job name • Date • Job ID