User guide

Advanced
User Guide 9-8
Security watermark is available only when these driver features are set as follows:
• Scaling set to 100%
• Print size set to 100%
• Gutter – Reduce Image to Fit set to Off
• Multiple pages per sheet set to Off
• Booklet set to Off
• Watermark set to Off
• Poster set to Off
• Kyocera Image Refinement (KIR) set to Off
• Resolution set to 600 dpi
• EcoPrint set to Off
• Monochrome Brightness and Contrast set to 0
• Custom color adjustment set to [None]
• Color correction set to Automatic
The Select security watermark list is constrained to [None] if any of these settings
are changed. The reverse also applies: if Security Watermark is set to anything other
than [None], the settings are constrained by the driver to the following values:
• Scaling set to 100%
• Print size set to the same size as Page size
• Gutter – Reduce Image to Fit set to Off
• Multiple pages per sheet set to Off (pages per sheet is set to 1)
• Booklet set to Off
• Watermark set to Off
• Poster set to Off
• Print Quality set as follows:
• Custom is set if it is one of the model’s options. Custom selections are
constrained as follows:
• Kyocera Image Refinement (KIR) set to Off
• Resolution set to 600 dpi
• EcoPrint set to Off
• If Custom is not one of the model’s options, 600 dpi, and either High Quality,
Proof, or Draft is set, depending on the printing system model.
• Monochrome Brightness and Contrast set to 0
• Custom color adjustment set to [None]
• Color correction set to Automatic
Select Security Watermark
Select a watermark from the Select security watermark drop-down list. The
selection list contains four standard security watermarks: Confidential 1,
Confidential 2, Sample and Copy. For details on creating your own watermarks,
see Add Security Watermark on page 9-9.
Note: The quality and effectiveness of the printed and photocopied security
watermark is dependent on the particular printing system and the settings used.
Before printing a security watermark, it is necessary to adjust the calibration and print
calibration pages. It is also necessary to adjust the calibration, then print calibration
pages, whenever certain changes are made to the printing system or security
watermark settings. See Adjust Calibration on page 9-12 for more information on
how to perform these important steps.