Specifications

Default Setting (System Menu)
8-26 OPERATION GUIDE
E-mail Subject/Body
Set the subject and body automatically entered (default subject and body) when sending the scanned originals
by E-mail.
NOTE: Refer to Send as E-mail on page 3-32.
Use the procedure below to set the default e-mail subject and message body.
1 Press the System Menu key.
2 Press [Common Settings], [ ], [Next] of Function
Defaults, [ ], and then [Change] of E-mail Subject/
Body.
3 Press [Subject] to enter an E-mail subject not more
than 60 characters.
NOTE: Refer to the Character Entry Method on
Appendix-7 for details on entering characters.
4 Press [OK].
5 Press [Body] to enter an E-mail Body not more than
500 characters.
6 Press [OK].
7 Check that the entries are correct and press [OK].
Border Erase Default
Set the default width to be erased as a border. The table below shows the measurement ranges that can be set.
NOTE: Refer to page 4-27 and page 5-26 for Border Erase.
Use the procedure below to set the default border erase width.
1 Press the System Menu key.
2 Press [Common Settings], [ ], [Next] of Function
Defaults, [ ] and then [Change] of Border Erase
Default.
3 Press [+] or [–] for the Border and Gutter width to
erase.
Input units Range
Inch 0 to 2" (in 0.01" increments)
Metric 0 mm to 50 mm (in 1 mm increments)