Installation Guide

Model: Ingot 2
Document Version 110322
Copper Labs, Inc. © 2020
INTENDED USE
Wireless Energy and Water Monitoring
PRODUCT REQUIREMENTS
● Smartphone running recent iOS or Android operating system.
● WiFi access point.
● Compatible wireless utility meter.
IMPORTANT SAFETY INFORMATION
● Read, keep, heed and follow all instructions.
● Warning: To reduce the risk of fire or electric shock, do not expose this device to
rain or moisture. Do not use this device near water or in wet locations. e.g.
bathrooms or outdoors.
● Clean only with dry soft cloth. Household cleaners or solvents can damage the
finish.
● Install in accordance with the manufacturer’s instructions.
● Do not install near any heat sources such as radiators, heat registers, stoves, or
other apparatus that produce heat.
● Unplug this device during lightning storms or when unused for long periods of
time.
● Refer all servicing to qualified service personnel. Servicing is required when the
device has been damaged in any way, such as plug is damaged or the device
has been exposed to rain or moisture, does not operate normally, or has been
dropped.
● The plug should be readily available to disconnect the equipment.
● Do not expose device to dripping or splashing and do not place objects filled with
liquids, such as vases, on the device.
● This device is not as a toy for usage by children.
● This device is not for use in safety-critical applications (such as life support)
where a failure of the product would reasonably be expected to cause severe
personal injury or death.
● If the equipment is used in a manner not specified by Copper Labs, the
protection provided by the equipment may be impaired.
SETUP AND INSTALLATION GUIDE