User guide

Data, Firmware, and Logs CME 2 User Guide
172 Copley Controls
16.5: Error Log
Copley amplifiers track faults and warnings in a log in flash memory.
View the CME 2 Error Log
1
Click the Error Log tool on the Main screen.
2
Click a tab to view a section of the log:
Tab
Contents
Active
Type and description of each active fault and warning. The contents of this tab are
automatically refreshed as new events occur.
History
Type, description, and time of occurrence of each fault and most warnings since the log
was last cleared. The contents of this tab are not refreshed automatically as new
events occur. The contents are refreshed only when the tab is displayed or when
Refresh is clicked.
Frequency
Type, description, and frequency of each fault and warning that has occurred since the
log was last cleared. The contents are refreshed only when the tab is displayed or
when Refresh is clicked.
CAN Network
(Under CAN control only.) Status of CAN bus. Lists warnings and errors.
3
To update the contents of the History or Frequency tabs, click Refresh.
4
To save the log to a disk file, click the Save to Disk icon on the log screen.
Then navigate to the appropriate folder, enter a File Name for the log, and click Save.
5
To clear the log if needed, press Clear Log. (Contents cannot be recovered.)
6
To close the log screen, click Close.