User guide

Parameter Dictionary About This Manual
Latching an output does not eliminate the risk of unexpected
motion with non-latched faults.
Associating a fault with a latched, custom-configured output does not
latch the fault itself. After the cause of a non-latched fault is corrected,
the drive re-enables without operator intervention. In this case, motion
may re-start unexpectedly.
For more information, see Fault Mask (0xA7)
When operating the drive as a CAN or DeviceNet node, the use of
CME 2 or ASCII serial commands may affect operations in progress.
Using such commands to initiate motion may cause network
operations to suspend.
Operation may restart unexpectedly when the commanded motion is
stopped.
Use equipment as described.
Operate drives within the specifications provided in the relevant
hardware manual or data sheet.
FAILURE TO HEED THESE WARNINGS CAN CAUSE EQUIPMENT
DAMAGE, INJURY, OR DEATH.
Revision History
Revision
Date
Comments
00
December 2013
Added new parameters and fixed existing content.
01
September 2014
Fixed units for parameter 0x5e
Copley Controls Page 6