User guide

Parameter Dictionary About This Manual
Copyrights
No part of this document may be reproduced in any form or by any means, electronic or mechanical, including photocopying, without express
written permission of Copley Controls.
Xenus, Accelnet, Stepnet, Accelus, and Junus are registered trademarks of Copley Controls.
CME 2 is a registered trademark of Copley Controls.
MACRO is a registered trademark of Delta Tau Corp.
Document Validity
We reserve the right to modify our products. The information in this document is subject to change without notice and does not represent a
commitment by Copley Controls. Copley Controls assumes no responsibility for any errors that may appear in this document.
Product Warnings
Observe all relevant state, regional, and local safety regulations when installing and using Copley Controls drives. For safety and to assure
compliance with documented system data, only Copley Controls should perform repairs to drives.
!
DANGER
Hazardous voltages.
Exercise caution when installing and adjusting Copley drives.
Risk of electric shock.
On some Copley Controls drives, high-voltage circuits are connected
to mains power. Refer to hardware documentation.
Risk of unexpected motion with non-latched faults.
After the cause of a non-latched fault is corrected, the drive re-
enables the PWM output stage without operator intervention. In this
case, motion may re-start unexpectedly. Configure faults as latched
unless a specific situation calls for non-latched behavior. When using
non-latched faults, be sure to safeguard against unexpected motion.
Copley Controls Page 5