User guide

About this Manual Xenus XTL User Guide
iv Copley Controls Corp.
Product Warnings
Observe all relevant state, regional, and local safety regulations when installing and using this
product. For safety and to assure compliance with documented system data, only Copley Controls
Corporation should perform repairs to amplifiers.
DANGER: Hazardous voltages.
!
DANGER
Exercise caution when installing and adjusting.
Failure to heed this warning can cause equipment damage, injury, or death.
Risk of electric shock.
!
DANGER
High-voltage circuits on J1, J2, and J3 are connected to mains power.
Failure to heed this warning can cause equipment damage, injury, or death.
Risk of unexpected motion with non-latched faults.
!
DANGER
After the cause of a non-latched fault is corrected, the amplifier re-enables the PWM
output stage without operator intervention. In this case, motion may re-start
unexpectedly. Configure faults as latched unless a specific situation calls for non-
latched behavior. When using non-latched faults, be sure to safeguard against
unexpected motion.
Failure to heed this warning can cause equipment damage, injury, or death.
Using CME 2 or serial commands may affect or suspend CAN operations.
!
DANGER
When operating the amplifier as a CAN node, the use of CME 2 or ASCII serial
commands may affect CAN operations in progress. Using such commands to initiate
motion may cause CAN operations to suspend.
CAN operations may restart unexpectedly when the commanded motion is stopped.
Failure to heed this warning can cause equipment damage, injury, or death.
Latching an output does not eliminate the risk of unexpected motion with non-
latched faults.
!
DANGER
Associating a fault with a latched, custom-configured output does not latch the fault
itself. After the cause of a non-latched fault is corrected, the amplifier re-enables
without operator intervention. In this case, motion may re-start unexpectedly.
For more information, see Clearing Non-Latched Faults (p. 26).
Failure to heed this warning can cause equipment damage, injury, or death.
Use equipment as described.
!
DANGER
Operate amplifiers within the specifications provided in this manual.
Failure to heed this warning can cause equipment damage, injury, or death.