User guide

ServoTube 25/38 Module User Guide
Page 9
Chapter 2
Installation
Chapter 2
Installation
UNPACKING
Check packaging for signs of damage.•
Remove packaging. Do not discard. In the event of items requiring return, it is recommended that the original •
packaging be used.
Metal surfaces may be hot or below 0•
o
C following prolonged storage.
Ensure that the delivery note correctly reects your order and the items delivered.•
Check equipment for signs of damage. Never use the equipment if it appears damaged in any way.•
Read the User Guide before installing and using this equipment.•
INSTALLATION
Intended operating environment
This equipment is intended for use in an environment within the following conditions:
Operating temperature 0 to +40 °C
Storage temperature -20 °C to +70 °C
Altitude (above mean sea level) 1000 m
Overvoltage category II
Pollution degree 2
EMC light industrial
Mechanical
Mounting module to user’s surface
For all modules, ensure that the mounting surface is as at as possible. The module can be mounted by two
methods:
Using the system clamp top xings. Both sides should be clamped with a distance between clamp centres of •
no more than 150 mm. Each M6 bolt should be tightened to a torque of 15 Nm.
Using the M5 T-nut slots on the underside of the module. This requires access from underneath the mounting •
surface. Both sides should be xed with a distance between xing centres of no more than 150 mm. Each M5
bolt should be tightened to a torque of 12 Nm.
All torque gures are non lubricated i.e. no thread lock.