User guide

Page 27
ServoTube 25/38 Module User Guide
Chapter 3
Maintenance
Replacement
Check the orientation of the thrust rod with regard to the end with the serial number label.•
Carefully slide the thrust rod in through the rst thrust rod support. Place spacers around or under the thrust •
rod as soon as it passes through the thrust rod support.
Continue to slide the thrust rod to pass through the forcer and into the other thrust rod support.•
Check the orientation of the thrust rod serial number label.•
Tighten the M10 xings in the thrust rod support to a torque of 50 Nm.•
Thrust rod removed
from module
Figure 3.14