SDS

Product name: COPIC INK
Prepared on: February 18, 2020
Revised on: April 21, 2020
5 / 14
3202112070116
Specific fire fighting method
:
Extremely low flash point: Spray water if there is no fire extinguishing
effect by other extinguishers.
If there is no risk, move the containers away from the fire zone.
Fight fire from the most distant place within the effective range using
unmanned hoses or monitored nozzles.
In the case of a large fire, extinguish the fire using unmanned hoses or
monitored nozzles. If this is not possible, evacuate from the fire and give
up extinguishing the fire.
Even after extinguishing the fire, the containers are sufficiently cooled
with a large amount of water.
Special protective actions for
fire-fighters
:
Use a self-contained breathing apparatus (SCBA) for a large fire.
Fire protection suits provide only limited protection in the event of a fire.
6. ACCIDENTAL RELEASE MEASURES
Personal precautions, protective
equipment and emergency procedures
:
Immediately isolate the leakage area as a leak zone with an appropriate
distance in all directions.
Keep unauthorized persons away.
Stay upwind. Keep out of low areas.
Do not touch or walk through the leaks.
Before entering into a confined place, ventilate the place.
Workers should wear appropriate protective equipment (see 8.
EXPOSURE CONTROLS/PERSONAL PROTECTION) to avoid
contact with eyes and skin, or inhalation.
Environmental precautions
:
Do not release into the environment.
Avoid environmental impacts caused by releasing the product to rivers,
etc.
Avoid inflow to drainage, sewage ditches, basements, or other confined
places.
Methods and materials for
containment and cleaning up
:
Remove all sources of ignition. (Prohibit smoking, sparks and open
flames in the vicinity.)
Stop leakage if safe to do so.
In small leakage: Use dry soil, sand, or non-flammable absorbent to
absorb or cover the leakage, and collect them in an empty container to be
tightly closed. Dispose of later.
In small leakage: Use clean, antistatic tools to collect the absorbed
leakage with the absorbent.
In large leakage: Prevent outflow by surrounding with embankment, lead
to a safe place, and collect it.
In large leakage, sprinkling water lowers the vapor concentration.
However, in a confined place, it may be unable to prevent combustion.
Ground all equipment used for handling the leakage.
Use vapour suppression foam to lower the vapour concentration.
Prevention of secondary disaster
:
Keep unauthorized persons away.
7. HANDLING AND STORAGE
Safe handling
Engineering measures
:
This product contains substances subject to risk assessment and being
dangerous substances (flammable) under the Industrial Safety and Health
Law. Also it falls under the category of flammable liquids under Fire