Installation & Assembly

1. Drill here using 7/32” drill bit
2. Using allen key & adjustable wrench, install
hardware as shown below
1. Drill here using 1/8” drill bit
2. Place Front Pin Bracket seen below
3. Using a screwdriver, install M4 x 15mm screws
Additional tools required:
7/32”
Drill Bit
Screwdriver
+
1/8”
Drill Bit
+
Adjustable wrench
+
1. Squarely align template on surface
2. Tape template in place before drilling
3. After ALL holes have been drilled, remove
template and install hardware as directed
Before beginning, you should:
READ THIS FIRST
®
2
Tech Tub Locking System Template
M4 x 15mm
4x
Front Pin Bracket
1x
Not to scale
D
Hardware
Actual Size
Screwdriver
Back Foot Anchor Pin
2x
A B
Hardware
Actual Size
C
M5 Washer
x2
M5 Lock Nut
x2
Table or Countertop
Maximum Thickness
1-1/2” or 38mm
Section View
B
C
A
Adjustable wrench
REMOVE TEMPLATE FROM AI BEFORE INSTALLATION PROCESS
REMOVE TEMPLATE FROM AI BEFORE INSTALLATION PROCESS
REMOVE TEMPLATE FROM AI BEFORE INSTALLATION PROCESS
5mm Drive
Allen Key
Not to Scale
1x
FTT600_FTT1000_FTT1000-USB_LockingPinDiagram_RevC_2016