User guide

ManualsBrandsCOP-USA ManualsVideoSDRDVR35

SDRDVR35

User Manual

COVERT SMOKE DETECTOR

Digital Recorder

Summary of content (10 pages)

PAGE 1
SDRDVR35 COVERT SMOKE DETECTOR Digital Recorder User Manual
PAGE 2
Package Specification .. ………………………………………………… ………… …………………………………… ………… Recording Capacity Estimator ..
PAGE 3
Model Number Compression Smoke Detector Portable DVR Storage Device External SD Card of Any Size Image Resolution Record:320 × 240 MPEG4 ,Snapshot: 320 × 240 JPEG Video Playback NTSC:30fps/sec , PAL: 25fps/sec.
PAGE 4
1. Camera 2. Power Switch for PDR 3. Reset Button. 4.
PAGE 5
1-2 IR Remote Control 1- Source: Video Source selection 2- Menu: System Menu 3- REC Recording Button 4- Capture Picture Capture Button 5- Enter Button Enter / Play Function 1-3 Camera To use the camera simply push the ON/OFF Button . To record, use your remote control REC Button on your remote control.
PAGE 6
1-4 Monitor installation VR OUT : Connect to the external monitor and earphone. 1-6 SD memory card installation you must open the lid to insert the SD Card Please make sure the SD card is in correct position before plug-in.
PAGE 7
5. Storage capacity status display SD card storage level display 2-2 System setting Press MENU button on control panel or remote controller. 2-2-1 Capacity display on/off.
PAGE 8
2-2-3 Time Setup - SYSTEM > DATE TIME – Date and time adjustment SYSTEM > DISPLAY ON – Date and Time display ON/OFF Setting Select options by using LEFT/RIGHT Arrows on the Remote Control and adjust values using UP/DOWN. - Select video system for AV OUT.
PAGE 9
2-2-6 Overwrite recording FUNCTION> OVER WRITE> ON/OFF OVER WRITE ON -The recorded video will be overwritten. OVER WRITE OFF -Recording will stop when SD card gets full. FUNCTION CAPTURE MODE Select the recording mode when motion triggered. SNAP 1 JPG: Capture a single JPG photo when motion detect function is triggered. VIDEO 5 SEC: Record video for 5 seconds when motion detect function is triggered. VIDEO 10 SEC: Record video for 10 seconds when motion detect function is triggered.
PAGE 10
Video recording -Press “REC” to start recording and press “REC” again to stop recording. -Please stop recording before press “MENU” to enter System setup menu -On Live Display , press left/right/down to enter Playback menu. Then, press up/ down to change page and press left/ right to select a file. After the file selected: -Press “ENTER” to play the video or display photo. -Press “MENU” for signal file deleting process -Press “CAPTURE” to go back to live display.