Instruction Manual

DVR User Manual

Step 3: Set sender‟s address and password.

Step 4: Set receiver‟s email address and click “Test” button to test the validity of the mailbox.

Fig 4-26 Network Configuration-Email

Attaching image: If selected, the system will attach images when sending emails.

4.6.4 Server

This function is mainly used for connecting ECMS/NVMS. The setting steps are as follows:

Step 1: In the server interface, select “Enable” as shown in the Fig 4-27.

Fig 4-27 Network Configuration-Server

Step 2: Check the IP address and port of the transfer media server in the ECMS/NVMS. The

default server port for auto report is 2009. If it is modified, please enter into the transfer media

interface to check.

Step 3: Enable the auto report in the ECMS/NVMS when adding a new device. Then input the

remaining information of the device in the ECMS/NVMS. After that, the system will auto allot

a Device ID. Please check it in the ECMS/NVMS.

Step 4: Input the above-mentioned server IP, server port and device ID in the server interface.

Then click “Apply” button to save the setting. Now, the ECMS/NVMS system will

automatically connect this device.