Instruction Manual

DVR User Manual

Step 2: Checkmark record and audio.

Step 3: Select All to setup the same settings for all channels.

4.3.2 Record Bitrate

Step 1: Enter into MenuSetupRecord Record Bitrate. Refer to Fig 4-12:

Step 2: Setup rate, resolution, quality, encode and max bit stream.

Step 3: Select “All” to set the same settings for all channels.

Step 4: Click “Apply” button to save the setting.

Fig 4-12 Record Configuration-Record Bitrate

If 960H Mode is checked in 8/16 CH DVR, only WD1 and CIF resolution can be selected and

the maximum number of frame you can choose is 12(PAL)/15(PAL).

If 960H Mode isn‟t enabled in 8/16 CH DVR, the resolution option includes D1, HD1 and CIF

and the maximum number of frame you can choose is 25(PAL)/30(PAL).

4.3.3 Time

Step 1: Enter into MenuSetupRecord  Time interface to set recording time. Refer to Fig

4-13:

Step 2: Set Pre-alarm record time and post-alarm record time. Select “All” to set the same

settings for all channels.

Pre-alarm Record Time: Set the time in seconds to pre-record before the actual recording

begins.

Parameter

Meaning

Rate

Range from 1-25/30 (related to the resolution you choose)

Resolution & Rate

Supports WD1, D1, HD1 and CIF(only applicable for 4 CH DVR)

Quality

The higher the value is, the clearer the recorded image is. Six options:

lowest, lower, low, medium, higher and highest.

Encode

VBR and CBR

Max bit stream

Range from: 768~2560kbps