User`s manual

16 Channel Digital Video Recorder
If you want to change the HDD between MASTER HDD and SLAVE HDD, just push mode
key, then push enter key to change, push menu to give up.
11.USB Backup
Plug in the USB device, go to the menu of Backup set, check that if the USB device was
detected or not, and the free space of the USB device is enough or not, select the backup mode,
then quit the menu setup.
In shift mode, if you select “STILL” for the backup mode in the Backup Set menu, push the
USB button, it begin to backup the main out picture to the USB device, there will be a “S” blinking
on the screen, when it stop blinking, the backup of the picture is done, you can plug the USB device
out and see the picture on a computer.
If you select “MOVIE” for the backup mode in the Backup Set menu, push the USB button in
shift mode, it begin to backup the main out video to the USB device from the moment, push USB
button again to select the end of the backup video, there will be a “A” blinking on the screen. This
may take a little time, and make sure the USB device has enough free space, if blinking stops, the
backup is ok, you can see the video on a computer with net viewer software
12.USB Update
Create a folder named “firmware” in the USB root directory, copy the update files to the
folder. Plug in the USB device, go to the menu of Backup set, check that if the USB device was
detected or not, go to the Firmware Update menu and select USB method, move to Update Start
and press enter button, update will start, if you see picture below, update is ok..
Then reboot the DVR.
NOTE: do not shut down the DVR when the DVR is updating, it may cause fatal problem.
33