User`s manual

or ADSL), and get the IP address from the ISP (Internet Service Provider). The framework to

perform this feature is depicted in the above figure. Moreover, please follow the procedure

described in section 5-8 “Network Setup” to setup the network configuration. Remember to

check that the fixed line(usually RJ45 cable) has connected to the DVR system correctly.

[Remote user site]

Please refer the following procedure (which is extracted from documents provided by

MicroSoft

Inc. to finish the setting of user site where a window 2000 system is installed.

 Windows 2000 Dial-Up Guide

 Step 1

Click Start on your Windows taskbar, select Run. Type ncpa.cpl in the Open field then

click OK to begin.

 Step 2