User`s manual

2.2.2 Install tool

One cross-screwdriver

2.2.3 Install process

⑴ Open the DVR by screwdriver

⑵ Set one as master and the other as slave if two HDDs are connected to one ATA interface!!!

Attention: Same HDD connected to parallel cable can not be set as master+master or slave+slave,

must be master+slave!!!

 HDD setup: Take the HDD of Maxtor (DiamondMax Plus 8 ATA/133 40GB) as example.

 Read the jumper cutline in the rear of HDD

No jumper=D

S(S

LAVE

)

DS(MASTER)

CS Enable

Cap limit