Service manual

GE MEDICAL SYSTEMS
D
IRECTION 2300749-100, REVISION 2LOGIQ
TM
3 SERVICE MANUAL
Chapter 8 8-21
8-2-7 System Setup
To complete the system setup:
1.) From the Touch Screen on the scanner, select Utility>Connectivity>TCPIP Tab.
2.) Ensure that DHCP is deselected so you can enter information manually.
3.) Input the DICOM information.
* This should be the appropriate DICOM information for the system if it is on the hospital
network. If it is not correct, input the correct data.
4.) After all information is entered select SAVE SETTINGS
.
5.) If the system is NOT on a network you will need to input a set of "dummy" data for proper InSite
and Diagnostic operation. Enter the following data if you are not on a network:
* Computer Name:
* IP Address: 3.192.28.253
* Subnet Mask: 255.255.255.0
6.) After all information is entered select SAVE SETTINGS
.
7.) Reset the VCR by going to Utilities>System>Setup.
8.) Select Sony 9500 VCR and SAVE
9.) Select Exit in the lower left-hand corner of the Touch Screen.
10.)Do an auto-shut down
11.)Press the ON/OFF
switch on the Control Panel once to display the SYSTEM - EXIT menu.
12.)Select SHUTDOWN
from the SYSTEM - EXIT menu.
Figure 8-20 System Exit Menu for Back-end Processor Power Down