Service manual

GE MEDICAL SYSTEMS
D
IRECTION 2300749-100, REVISION 2 LOGIQ
TM
3 SERVICE MANUAL
8-18 Section 8-2 - Loading Application Software After a Base Image Load
8-10-5 Loading Applications Software (cont’d)
5.) As indicated, press any key to continue. The process is completely automated and provides
you with messages as to its status. R2.0.2 Software provides the message in Figure 8-85.
At this point you just have to wait while the software loads (Approximately 10 minutes).
Near the end of the software install, the installation script will check to see if Direct CD needs to be
updated. If Direct CD is updated, several more windows will appear. These windows will be handled
automatically.
6.) When it completes loading the system will reboot.
If possible while the system is rebooting remove the CD from the drive. If the CD is remove the system
will automatically reboot into the applications software.
If you didn’t remove the CD, don’t worry you will get a dialog box as in Figure 8-86.
Figure 8-17 Command Window
Figure 8-18 R1.1.1 Software Message