Service manual

GE MEDICAL SYSTEMS
D
IRECTION 2300749-100, REVISION 2 LOGIQ
TM
3 SERVICE MANUAL
4-10 Section 4-3 - General Procedure
4-3-4 Adjusting the Display Monitor
4-3-4-1 Brightness and Contrast
To adjust the brightness:
1.) Press the Center button of the display monitor twice.
2.) Press the Right button to increase brightness.
Press the Left button to decrease brightness.
The amount of brightness is shown on a slider on the screen.
To adjust the contrast:
1.) Press the Center button of the display monitor once.
2.) Press the Right button to increase the contrast.
Press the Left button to increase the contrast.
The amount of the contrast is shown on a slider on the screen.
4-3-4-2 Manual Degauss
To activate the manual degauss:
1.) Press the Center button until menu OSD appears on the screen.
2.) Press the toggle button for brightness and contrast.
3.) Press the Decrease or Increase monitor adjustment button and select degauss now.
4.) Monitor degaussing is done.
4-3-5 Lockout/Tagout Requirements (For USA/Europe Only)
Follow OSHA Lockout/Tagout requirements by ensuring you are in total control of the plug.
NOTICE
Lockout/Tagout Requirements (For USA / Europe only)
Follow OSHA Lockout/Tagout requirements by ensuring you are in total control of the Power Cable
on the system.
Signed
Date
TA G
&
LOCKOUT