Service manual

GE MEDICAL SYSTEMS
D
IRECTION 2300749-100, REVISION 2LOGIQ
TM
3 SERVICE MANUAL
Chapter 4 4-5
b.) Press and hold EJECT button while the system is booting.
c.) Mechanical ejection. Insert the end of a paper clip into the hole next to the EJECT button while
system power is OFF.
4-3-2-2 Using MOD (Optional)
NOTE: MOD can be installed through USB Port of LOGIQ™ 3
1.) Before installing an MO disk in the MOD, check the MO disk for loose hardware or damaged labels
which could jam inside the MO Drive. Also ensure that the slide switch in one corner of the disk is
set so that the disk is write enabled (disk hole closed).
2.) Insert the disk into the MOD with the label facing up.
3.) The are a number of methods to eject a disk from the MOD. Ejection is automatic in some cases.
Manual ejection methods, listed in preferred order of use, are:
a.) Press EJECT
button on the MOD while system is ON.
b.) Press and hold EJECT
button while the system is booting.
c.) Mechanical eject. Insert the end of a paper clip into the hole next to the EJECT button while
NOTICE
Avoid mechanical ejection whenever possible. Mechanical ejection leaves the actuator
unlocked and the CDR-W susceptible to damage if moved. If forced to use this method,
reboot the system, then insert and eject a known good disk using one of the other methods.
Figure 4-4 CD-RW drives
NOTICE
Never move the unit with a disk in the MOD because the drive actuator will not be locked and
the MOD could break.
3
CD R/W Drive
Eject Button