Service manual

GE MEDICAL SYSTEMS
D
IRECTION 2300749-100, REVISION 2 LOGIQ
TM
3 SERVICE MANUAL
4-4 Section 4-3 - General Procedure
4-3-1 Power On/Boot Up (cont’d)
When the Standby switch on the Control Panel is pressed once, the Back-end Processor starts and the
software code is distributed to initiate the scanner.
No status messages are displayed during this process.
4-3-1-2 Power Off
Purpose: This is a description on how to Shutdown the system.
1.) Press the ON/OFF
keys on the keyboard
2.) The System Exit dialog box is displayed on the monitor.
Select “Shutdown” from the System Exit dialog box.
3.) The power off sequence begins. The system power turns off automatically when the power off
sequence is completed.
4-3-1-3 Power Shutdown
1.) Press the ON/OFF
key at the front of the System once.
2.) The System Exit dialog box is displayed on the monitor.
Select “Shutdown” from the System Exit dialog box
3.) Switch OFF the Main Circuit Breaker at the rear of the system Refer to Figure 4-1 on page 3 .
4.) Disconnect the Main Power Cable if needed.
4-3-2 Using CD-RW Drive/MOD Drive (Optional)
4-3-2-1 Using CD-RW
1.) Push the EJECT
button, the disk tray will appear.
2.) Put the disk onto the disk tray.
3.) Press the EJECT
button to insert the disk into the CD-RW device.
4.) There are a number of methods to eject a disk from the CD-RW. Ejection is automatic in some
cases. Manual ejection methods, listed in preferred order of use, are:
a.) Press EJECT
button on the CD-RW while system is ON.
Figure 4-3 System Exit Dialog Box
NOTICE
Never move the unit with a disk in the CD-RW because the drive actuator will not be locked
and the CD-RW could break.