Service manual

GE MEDICAL SYSTEMS
D
IRECTION 2300749-100, REVISION 2LOGIQ
TM
3 SERVICE MANUAL
Chapter 4 4-3
4-3-1 Power On/Boot Up (cont’d)
When power is applied to the Scanner, and the Rear Circuit breaker is turned ON, Power is distributed
to the Transformer Assembly. When the Control panel ON/OFF
key is pressed once, Fans, Control
Panel, Monitor, Internal and External I/O’s, Nest Boards, Peripherals and the Back End Processor are
given power. Back-end Processor boots up and the system starts in the scanning mode.
Press the ON/OFF (STANDBY)
Switch on the Control Panel once.
Figure 4-1 Circuit Breaker
Figure 4-2 Power On/Off Standby Switch Location
Circuit Breaker
Power Cable
3