Service manual

Service manual E000129004
3
To gain access to the parts located inside the control
panel proceed with steps 1 and 2 than:
3 Remove the screws I (fig 6).
4 Remove the lid J
5 Re-assemble in reverse order.
Fig 6
1.8. Condensate trap route
The plastic pipe K (fig 7) that connects the condensate
collector with the condensate drain pipe has also the
function of condensate trap.
For this reason, if the pipe K needs to be removed during
service operations, it is very important to re-install
routing it as shown in figure 7.
Fig 7