Instruction Manual

Part Number: PIB01013 Page 10 of 17
Revision B Revision Date: January 2018
If you find that your vision is still blurred after checking the above possibilities, remove
both lenses and consult your eye care practitioner.
4. Centering the Lens:
Very rarely, a lens that is on the cornea will be displaced onto the white part of the eye
during lens wear. This can also occur during placement and removal of the lenses if the
correct techniques are not performed properly. To center a lens, follow one of the
procedures below:
a. Close your eyelids and gently massage the lens into place through the
closed lids, using your index finger.
b. Gently push the off-centered lens onto the cornea while the eye is
open using finger pressure on the edge of the upper or lower eyelid.
5. Removing the Lens:
CAUTION: Always be sure that the lens is centered on the cornea before attempting to remove it.
Determine this by covering the other eye. If the vision is blurred, the lens is either on the white part
of the eye or it is not on the eye at all. To locate the lens, inspect the upper area of the eye by
looking down into a mirror while pulling the upper lid up. Then, inspect the lower area by pulling the
lower lid down.
Wash, rinse, and dry your hands thoroughly with mild soap, rinse completely, and dry with a lint-free
towel before touching lenses. Have your storage container or carrying case ready to put the lenses in
upon removal.
Always be sure that the lens is centered on the cornea before attempting to remove it.
a. Look straight ahead and up slightly. With the middle finger of your
dominant hand, pull the lower lid down slightly.
b. Gently pinch the lens between the index finger and thumb of your
dominant hand.
c. Gently pull the lens away from the eye.
d. Repeat the above procedure for the other lens.
Note: If this method of removing your lenses is difficult for you, your eye care
practitioner will provide you with an alternative method.